Selecting Track Plotting Interval - Furuno GP-90 Operator's Manual

2. TRACK
Are you sure to erase ?
ENT: Yes
Figure 2-6 Prompt for erasure
of track
5) Press the [NU/CU ENT] key.
2.9 Selecting Track Plotting
Interval
The plotting interval determines both how the
track will be reconstructed on the display and
track storage time. A shorter interval
provides more accurate reconstruction of
track line, however total storage time is
reduced. The plotting interval can be selected
by time or distance. Plotting by distance
offers the advantage that the track is not
stored when the vessel is anchored.
Plotting interval by time
The setting range for plotting by time is 00 to
60 minutes.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
TRACK/MARK SETUP
Track Rec
Time
(01'00)
Mark Shape
Mark Line
Event Mark
: Select
ENT: Enter
MENU: Escape
Figure 2-7 TRACK/MARK SETUP menu
2-4
MENU: No
Dist
(00.50nm)
3) Press or to select Track Rec.
4) Press to select Time.
5) Enter plotting interval in four digits. To
enter 30 seconds, for example, press [0]
[0] [3] [0].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.
Plotting interval by distance
The setting range for plotting by distance is
0.01 to 99.99 nautical miles. To plot all track,
enter 00.00.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
3) Press or to select Track Rec.
4) Press to select Distance.
5) Enter plotting interval. To enter 0.1
nautical miles, for example, press [0] [0]
[1].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.