Selecting Track Plotting Interval - Furuno GP-80 Operator's Manual

Are you sure to erase ?
ENT: Yes
Figure 2-6 Prompt for erasure
of track, mark
5) Press the [NU/CU ENT] key.
2.9 Selecting Track Plotting
Interval
The plotting interval determines both how the
track will be reconstructed on the display and
track storage time. A shorter interval provides
more accurate reconstruction of track line,
however total storage time is reduced. The
plotting interval can be selected by time or
distance. Plotting by distance offers the ad-
vantage that the track is not stored when the
vessel is anchored.
Plotting interval by time
The setting range for plotting by time is 00 to
60 minutes.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
TRACK/MARK SETUP
Track Rec
(01'00)
Mark Shape
Mark Line
Event Mark
: Select
ENT: Enter
Figure 2-7 TRACK/MARK SETUP menu
2 – 4
MENU: No
Time
Dist
(00.50nm)
MENU: Escape
3) Press or to select Track Rec.
4) Press t to select Time.
5) Enter plotting interval in four digits. To
enter 30 seconds, for example, press [0]
[0] [3] [0].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.
Plotting interval by distance
The setting range for plotting by distance is
0.01 to 99.99 nautical miles. To plot all track,
enter 00.00.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
3) Press or to select Track Rec.
4) Press s to select Distance.
5) Enter plotting interval. To enter 0.1 nauti-
cal miles, for example, press [0] [0] [1].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.