Furuno GP-150 Operator's Manual page 51

Entering GPS speed smoothing
1) Press MENU ESC, 9 and 6.
2) Press or to select Spd.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Entering speed averaging
1) Press MENU ESC, 9 and 6.
2) Press or to select Speed Average.
3) Enter smoothing factor in two digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Selecting RAIM Function
1) Press MENU ESC, 9 and 6.
2) Press or to select RAIM Function
on page 2/2.
GPS SETUP
To Previous Page
RAIM Function OFF
RAIM Accuracy 100 m
Geodetic Datum WGS84 NAD27 OTHER
(Cannot be changed)
Posn Offset 0.000' N 0.000' E
Time Diff. +00:00
Posn 38 00.000' N 123 00.000' W
: Select
MENU : Escape
Figure 8-2 GPS SETUP menu, page 2/2
3) Press or to select RAIM Function
desired.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Entering RAIM Accuracy
1) Press MENU ESC, 9 and 6.
2) Press or to select RAIM Accuracy
on page 2/2.
3) Key in the range for which you want to
know RAIM Accuracy (1 to 999 m).
Note: Unit is meter only.
2/2
ON
(001)
ENT : Enter
: +/-
4) Press the NU/CU ENT key.
Press the MENU ESC key.
Entering geodetic datum
1) Press MENU ESC, 9 and 6.
2) Press or to select Geodetic
Datum on page 2/2.
3) Press or to select geodetic datum
to use. For geodetic datum other than
WGS-84 or NAD-27, select OTHER and
key in chart number (001-173) referring
to the geodetic chart list in the Appendix.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Entering position offset
If you do not know the type of chart you are
using, GPS position may be wrong. Note the
difference in position when moored to a pier
and enter it on the GPS SETUP menu, to get
correct position.
1) Press MENU ESC, 9 and 6.
2) Press or to select Posn Offset on
page 2/2.
3) If necessary press
north latitude to south latitude or vice
versa.
4) Key in latitude correction.
5) If necessary press
east longitude to west longitude or vice
versa.
6) Key in longitude correction.
7) Press the NU/CU ENT key.
8) Press the MENU ESC key.
L
The icon appears when L/L offset is
L
applied.
Entering time difference
1) Press MENU ESC, 9 and 6.
2) Press or to select Time Diff on
page 2/2.
3) Key in time difference (-14:00 to +14:00).
4) Press to change from plus to minus
or vice versa.
5) Press the MENU ESC key.
8. MENU SETTINGS
to switch from
to switch from
8-3