Furuno GP-150 Operator's Manual page 26

4. NAVIGATION PLANNING
6) Press to select waypoint mark shape.
The following display appears.
: Cursor
ENT: Enter
MENU: Escape
Figure 4-4 Screen for selecting waypoint
mark shape
7) Press or to select mark shape.
8) Press the NU/CU ENT key. The display
shown in Figure 4-5 appears.
A
ABCDE FGHIJ KLMNO PQRST UVWXYZ
fghij
abcde klmno
1 2 3 4 5 6 7 8 9 0 _ # % ' ( ) + - . / : ; < = > ?
ENTER
_ _ _ _ _ _ _ _ _ _ _ _
COMMENT:
: Cursor
MENU: Escape
ENT: Set
Figure 4-5 Screen for entry of
comment for waypoint
9) You may enter a comment, as shown in
the procedure which follows, or skip to
step 10 to finish. The comment may
consist of up to 12 alphanumeric
characters.
1
Press the cursor keys to select
alphanumeric character.
2
Press the NU/CU ENT key. Selected
character appears on the COMMENT
line.
To create a space, select "_".
Numeric data can be input directly by
pressing numeric keys.
To clear wrong data, press the
CLEAR key.
3
Repeat steps 1 and 2 to complete the
comment.
4
Select ENTER and press the NU/CU
ENT key.
4-2
pqrst uvwxyz
10) Press the NU/CU ENT key.
Control is returned to the last used
display mode.
When the waypoint number entered at
step 5 already exists, the message
shown in Figure 4-4 appears if the
waypoint is part of the current destination
or route or is part of a route. If it is alright
to write over the waypoint and its data,
press the NU/CU ENT key. To change
waypoint number, press the MENU ESC
key.
1st line
Are you sure to change ?
ENT: Yes
This wpt is GOTO
This wpt is in registered route
This wpt is in selected route
Figure 4-6
Note: If you fail to enter waypoint number,
"Enter waypoint number" appears on
the display for three seconds.
MENU: No