Supervisor And User Security - TYAN S1846 User Manual

Supervisor and User Security

You can limit access to the Setup Program or to the system using the Supervi-
sor and User password options (the Supervisor password gives you access to
the Setup Program and the system; the User password, only to the system).
Note that you must create a supervisor password before you create a user
password. If you select the User Security option first, the following dialog box
will appear:
When you select the Supervisor Security option, a dialog box (shown below)
will appear, allowing you to enter a password. You may either type the pass-
word in, or click on the onscreen buttons. Your password must be between one
and six characters long.
Once you have entered your new password, you will be asked to confirm it. If
the two passwords do not match, you will be prompted to enter a new pass-
word, and then to confirm it. This will continue until you enter the same series
of characters both times. Once this is accomplished, a dialog box will appear
and notify you that the Supervisor Password has been installed. You may then
S1846 Tsunami ATX
63