Supervisor And User Security - TYAN THUNDER 100 Manual

Chapter 4
BIOS Configuration
OnBoard Parallel Port is set to 278 or 378. The settings are 5 or 7.
Parallel Port DMA Channel
This option is only available if the setting for the Parallel Port Mode option is
set to ECP and the OnBoard Parallel Port option is set to 378, 278, or 3BC. This
option sets the DMA channel used by the parallel port. The settings are 0
through 7 in increments of one.
Onboard IDE
This option specifies the IDE channel used by the onboard IDE controller. The
settings are Disabled, Primary, Secondary, or Both.

Supervisor and User Security

You can limit access to the Setup Program or to the system using the Supervi-
sor and User password options (the Supervisor password gives you access to
the Setup Program and the system; the User password, only to the system).
Note that you must create a supervisor password before you create a user
password.
(c)1998 American Megatrends, Inc. All Rights Reserved
Main Advanced
Set Supervisor Password [ Enter ]
Set User Password [ Enter ]
ESC:Exit Enter:Select F5:Setup Defaults F6:Original Values F10:Save & Exit
AMI BIOS EASY SETUP UTILITY Ver.1.16
Security Exit
84
Setup Help
Change the supervisor
password
-
Previous Item
¯
Next Item
® ¬ Select Menu
http://www.tyan.com