Daily Maintenance - MUTOH vj-1617h Operation Manual

Maintenance
6.2

Daily maintenance

Perform the following operation after the operation at the end of the day.
NOTE
• The contents in this section is the same as the "User maintenance sheet" provided with the printer.
This section describes how to clean the cleaning wiper unit, surrounding area for the cleaning wiper unit,
and around the print head.
(1) Cleaning time
Once a day, after operating for the day.
(2) Cleaning method
Follow the procedure below to clean the cleaning wiper and its surrounding area and around the print
head.
CAUTION
• When cleaning the cleaning wiper and around the print head, the print head cap will
be removed, and therefore cleaning must be completed before the print head dries.
The recommended time for cleaning is about 5 minutes.
If cleaning exceeds 5 minutes, suspend cleaning. Perform Head cleaning, and then
start cleaning again.
6.5.3 Head cleaning
NOTE
• For the cleaning procedure, refer to the attached maintenance sheet.
• Use the following parts below to clean the cleaning wiper unit, surrounding area for the cleaning
wiper unit, and around the print head.
• Cleaning fluid
• Cleaning stick
• Plastic cup
• Dropper
8.3 Options/Supply list
• Paper towels (not included with the printer. Prepare them boforehand.)
1. Pour 50ml of cleaning fluid into the provided plastic cup and dip the cleaning stick in it.
2. Perform either of the followings until "CR Mainte.: Start" displays on Operation panel.
VJ-1617H OPERATION MANUAL
6-6