Vacuum Fan Menu - MUTOH vj-1617h Operation Manual

Panel setup menu
5.2.2.4

Vacuum Fan menu

Sets up vacuum fan operation.
Setup item
Vacuum Fan
5.2.2.5 Media thickness menu
Functions of media thickness menu differ depending on the media thickness detection settings.
• If the media thickness detection menu is set to Off, use this to enter and set the media thickness.
5.2.2.5.2 Media thickness confirmation menu
• If the media thickness detection menu is set to On, the detected media thickness is displayed.
5.2.2.5.2 Media thickness confirmation menu
For media detection settings, refer to the following.
5.2.2.7.1 Media thickness detection (media initial 1)
5.2.2.5.1 Media thickness menu
When using the rigid media with a soft printing surface, the media thickness may not be detected
correctly.
When this happens, set the media thickness detection menu to Off, measure the media thickness with a
tool such as slide gauge, and then enter the media thickness in this menu.
WARNING
If you set a value smaller than the actual media thickness, the media may touch and break Print head.
Setting
Low
Middle
<High>
Off
—
VJ-1617H OPERATION MANUAL
Description
Set when there is a possibility of a paper jam caused by failure
in media loading when using soft media.
Set this when using general media and the adsorption power is
too strong if it is set to High.
Set when using general media.
The vacuum fan is not used.
Set when using thick media.
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.2 User Type menu
5-14