Cub Crafters CC18-180 Pilot Operating Handbook page 394

SECTION 9.13
SUPPLEMENTS-WIPAIRE 2100S
SEAPLANE FLOATS
 Mixture ........................................................ Idle cut off
 Ignition ..................................................................... Off
 Master switch .......................................................... Off
9.13.4.5
This section will amplify specific procedures that relate to
the operation of the aircraft equipped with Wipaire 2100S
seaplane floats. For amplified procedures that are
common to the landplane and the floatplane, please refer
to section 4 of this manual.
Preflight
9.13.4.5.1
Check the operation, retraction and extension of the
water rudders.
To determine the fuel quantity on the water, use the fuel
quantity indication for level flight. Fuel indications in the
water will vary depending on the angle at which the
aircraft is floating.
The bilge pump is located in the right float hatch. To
empty the floats of water, remove the rubber plugs, and
pump any accumulated water. Once the process is
complete make sure that the rubber plugs are fitted
tightly.
9.13.5 PERFORMANCE
9.13.5.1
The purpose of this section is to provide information that
will assist the pilot of a CC18-180 equipped with
WIPAIRE 2100S seaplane floats with planning a flight in
detail with reasonable accuracy.
REPORT TC10000AFM
Page Number: 9-13-20
AMPLIFIED PROCEDURES
INTRODUCTION
CUB CRAFTERS
Issued: 10/09/12
Date of Revision: 09/15/15
CC18-180