Cub Crafters CC18-180 Pilot Operating Handbook page 208

SECTION 9.3
SUPPLEMENTS-GTX 327
9.3.7.4 Keys for other GTX 327 Functions
IDENT- Pressing the IDENT key activates
the Special Position Identification (SPI)
Pulse for 18 seconds, identifying your
transponder
controller's screen. The word "IDENT" will
appear in the upper left corner of the display
while the IDENT mode is active.
VFR- Sets the transponder code to the pre-
programmed
Configuration Mode (this is set to 1200 at
the factory). Pressing the VFR key again will
restore the previous identification code.
FUNC- Changes the page shown on the
right side of the display. Displayed data
includes Pressure Altitude, Flight Time,
Count Up timer and Count Down timer. In
the configuration mode it steps through the
configuration pages.
START/STOP- Starts and stops the count
up and count down timers.
CRSR- Initiates entry of the starting time for
the
transponder code entry.
REPORT TC10000AFM
Page number 9-3-8
return
code
Count Down
CUB CRAFTERS
CC18-180
on the air
selected
timer and
Issued: 5/31/05
Date of revision: 12/06/05
traffic
in the
cancels