Cub Crafters CC18-180 Pilot Operating Handbook page 330

SECTION 9.11
SUPPLEMENTS-WIPAIRE 2100A
AMPHIBIOUS FLOATS
9.11.4.4.24
 Parking brakes (on wheels) .................................. Set
 Flaps ................................................................ Retract
 Electrical equipment ............................................... Off
 Avionics master switch ........................................... Off
 Throttle .................................................................. Idle
 Mixture ........................................................ Idle cut off
 Magnetos ................................................................ Off
 Master switch .......................................................... Off
9.11.4.5 AMPLIFIED PROCEDURES
This section will amplify specific procedures that relate to
the operation of the aircraft equipped with Wipaire 2100A
amphibious floats. For amplified procedures that are
common to the landplane and the floatplane, please refer
to section 4 of this manual.
Preflight
9.11.4.5.1
Ensure that the landing gear selector is in the correct
position and after turning on the aircraft's electrical
power, make certain that the landing gear indication is
correct. Check the operation, retraction and extension of
the water rudders.
To determine the fuel quantity on the ground, use the fuel
quantity indication for level flight. Fuel indications in the
water will vary depending on the angle at which the
aircraft is floating.
The bilge pump is located in the right float hatch. To
empty the floats of water, remove the rubber plugs, and
pump any accumulated water. Once the process is
complete make sure that the rubber plugs are fitted
tightly.
REPORT TC10000AFM
Page Number: 9-11-28
Stopping Engine
CUB CRAFTERS
CC18-180
Issued: 5/31/05
Date of Revision: 09/15/15