CUB CRAFTERS
CC18-180
9.13.4.4.8
Battery master switch ............................................. On
Beacon .................................................................... On
Ignition switches .............................................. Both on
Mixture ............................................................ Full rich
Primer ................................................................ Apply*
Throttle ................................................... Open 1/2 inch
Starter ............................................................. Engage
After engine has started:
Oil pressure ....................................................... Check
Throttle .................................................. Set 1000 RPM
Lights ......................................................... As required
Avionics master switch ........................................... On
*Normal procedure 3 times. If engine is hot, omit this
step.
9.13.4.4.9
Ignition .................................................................. Both
Mixture ........................................................ Idle cut-off
Throttle .......................................................... Full open
Starter ............................................................. Engage
When engine fires:
Mixture .................................................................. Rich
Throttle ........................................ Retard to 1000 RPM
Oil pressure ....................................................... Check
Lights ......................................................... As required
Avionics master switch ........................................... On
9.13.4.4.10
Throttle ............................................. 1000 to 1200 RPM
Issued: 10/09/12
Date of Revision: 09/15/15
SUPPLEMENTS- WIPAIRE 2100S
Starting Engine
Starting Engine When Flooded
Warm up
SECTION 9.13
SEAPLANE FLOATS
REPORT TC10000AFM
Page Number: 9-13-15