Gear Group Disassembling - MV Agusta Brutale 990 R Service Manual

Gear group disassembling

Remove the clutch following the instructions in the
relative paragraph.
Remove the clutch rod from the clutch end.
Remove the 6 tightening screws from the gear cap.
Using a rubber hammer, delicately beat on the
primary shaft from the clutch end holding a hand
on the gear cap until it moves from the crankcase.
Slide the gear group out.
Do not invert the position of the forks on the
secondary shaft. If this occurs, it will be
necessary to restore the correct condition
using tool n° 8A0094792.
It is important to reassemble the clutch rod
from the cylindrical side of the clutch control
(left side of engine) in order to prevent the oil
seal from damaging (1). See the illustration
on page 53 with the slot for the lubrication
facing towards the clutch side.
ENGINE BLOCK
- 17 -
D