The clutch release occurs using a post poning
return group composed of a small thrust piston
placed on the left side of the motor and operated
by a hydraulic system. This small piston pushes a
command rod which makes the disk pusher plate
function.
Clutch disassembly (procedure standard)
Remove the 11 screws which fasten the clutch cap
to the Crankcase.
D
Remove the clutch cap together with the gasket
which will be substituted during reassembly.
In order to carry out this function the following
special tool is necessary:
Utensil n°800079015
Remove the 6 disk pusher plate tightening screws
together with the springs and the relative holders.
Remove the disk pusher plate.
If the friction rod must be slipped off, it is
important to replace it from the cylindrical side
of the friction control (left side of the engine)
in order to prevent the oil seal (1)from
damaging. See the illustration on the following
page with the slot for the lubrication facing
towards the friction side.
ENGINE BLOCK
- 4 -
800079015