Procom FBD28T Owner's Operation And Installation Manual page 13

3. Attach gas line to fireplace gas regulator.
See Connecting to Gas Supply, page 14.
4. Check all gas connections for leaks. See
Checking Gas Connections, page 16.
IMPORTANT: When finishing your firebox,
combustible materials such as wall board,
gypsum board, sheet rock, drywall, plywood,
etc, must have 1/2" clearance to the sides
and top of the firebox. Combustible materials
should never overlap the firebox front.
CAUTION: Do not operate
fireplace without hood in place.
1. Fireplace hood is positioned on top of
shipping inner pack.
2. Remove top of firebox by removing 2 screws
located on each end (see Figure 11).
3. Insert the hood along the upper side of
the heat insulation board (see Figure 11).
Attach hood with 3 screws.
4. Reattach firebox top by reinserting the 2
screws from step 2.
200014-01A
INSTALLATION
Figure 10 - Rough Opening for Corner
ASSEMBLING HOOD
Step 1
Step 2
Hood
Step 3
www.usaprocom.com
Installation
Remove 2
Screws from Top
Firebox Panel
Insulation
Board
Replace 2
Screws
Figure 11 - Hood Installation
13