Battery Installation And Charging - AT&T TL92271 User Manual

Getting started

Battery installation and charging

Install the battery as shown below.
Step 1
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
color-coded label. Insert the supplied
battery with the label THIS SIDE UP
facing up as indicated.
CHARGE light
To replace the battery, press the tab and slide the
battery compartment cover downwards. Lift out the old
battery and disconnect it from the handset. Follow the
instructions above to install and charge the new battery.
IMPORTANT INFORMATION:
• Use only the supplied rechargeable battery or replacement battery (model BT166342).
To order, visit our website at
1 (800) 222-3111
• If you do not use the handset for a long time, disconnect and remove the battery to prevent
possible leakage.
Step 3
Charge the handset by placing it face up
in the telephone base or charger. The
CHARGE light is on when charging.
After you install your telephone or
power returns following a power outage,
the handset will prompt you to set the
date and time. For instructions, see
Set date and time on page 28. To skip
setting the date and time, press
OFF/CANCEL or BACK.
www.telephones.att.com
. In Canada, dial
Step 2
Align the cover flat against the
battery compartment, then slide it
upwards until it clicks into place.
1 (866) 288-4268
8
SET DATE
--/--/--
MM/DD/YY
BACK SET
SET TIME
--:-- --
BACK SET
or call
.