Remote Access Code; Message Alert Tone - AT&T TL92271 User Manual

Answering system
Answering system settings

Remote access code

A 2-digit security code is required to access the answering system remotely
from any touch-tone telephone. The preset code is 19. You can change the
code to any number from 00 to 99.
To change the remote code:
1. Press MENU
main menu.
CID or DIR to scroll to Answering sys, then
2. Use
press SELECT.
3. Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
4. Press CID or DIR to scroll to Remote code, then
press SELECT.
5. Use the dialing keys (0-9) to enter a 2-digit number
from 00-99.
• Press
MUTE
• Press and hold
• Press CID or DIR to move the cursor to the right or left.
Press SET to save. You hear a confirmation tone.

Message alert tone

When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you to new messages. The tone stops when all new
messages have been reviewed. The default message alert tone setting is Off.
To change the setting:
1. Press MENU
main menu.
CID or DIR to scroll to Answering sys, then
2. Use
press SELECT.
CID or DIR to scroll to Ans sys setup, then
3. Use
press SELECT.
4. Press CID or DIR to scroll to Msg alert tone, then
press SELECT.
5. Press CID or DIR to choose between On and Off,
then press SET
NOTE: You cannot set the message alert tone when another handset or the telephone
base is accessing the answering system.
on the handset in idle mode to enter the
/DELETE to erase a digit.
/DELETE to erase all digits.
MUTE
on the handset in idle mode to enter the
to save your setting. You hear a confirmation tone.
79
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SET
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SET