Silencing The Alarm; Service And Support - Lenovo 5594-6KX Installation And User Manual

Silencing the alarm

Procedure
1. Press the ESC (Escape) button on the front panel display to silence the alarm.
2. Perform the applicable action to resolve the alarm condition. If the alarm status

Service and support

If you have any questions or problems with the UPS, call your Local Distributor or
your local service representative and ask for a UPS technical representative.
Have the following information ready when you call for service:
v Equipment type and model number
v Serial number
v Firmware version number
v Date of failure or problem
v Symptoms of failure or problem
v Customer address and contact information
If repair is required, you will be given a Returned Material Authorization (RMA)
number. This number must appear on the outside of the package and on the Bill
Of Lading (if applicable). Use the original packaging or request packaging from
your local service representative or distributor. Units damaged in shipment as a
result of improper packaging are not covered under warranty. A replacement or
repair unit will be shipped, freight prepaid for all warrantied units.
Note: For critical applications, immediate replacement might be available. Call
your local service representative or the distributor nearest you.
46
Installation and User's Guide
Conditions Possible cause
MBP disconnected The HotSwap MBP is not
detected.
changes, the alarm beeps again, overriding the previous alarm silencing.
Action
If the HotSwap MBP is
connected to the UPS, check that
the detection connector is
correctly plugged.