To install the UPS:
Procedure
1. Remove the center cover of the front bezel.
2. Loosen the two screws to open the left side of the front bezel.
3. Remove the two screws to pull out the metal protection cover of the battery
4. Connect the two battery-pack connectors together.
5. Screw back the metal protection cover and the front bezel, then clip the center
Connecting the EBM(s)
About this task
Note: A small amount of arcing might occur when connecting EBMs. This is
normal and will not harm personnel. Insert the EBM cable into the battery
connector quickly and firmly.
Procedure
1. Plug the EBM power cable(s) into the battery connector(s). Up to four EBMs
2. Verify that the EBM connections are tight and that strain relief exists for each
3. Connect the battery detection cable(s) to the connector of the UPS and of the
20
Installation and User's Guide
pack.
Note: A ribbon cable connects the LCD control panel to the UPS. Do not pull
on the cable or disconnect it.
Note: A small amount of arcing might occur when connecting the battery pack.
This is normal and does not damage the UPS or present any safety concern.
cover.
can be connected to the UPS.
cable.
EBM(s).