Chapter 5. Operation; Ups Startup And Shutdown; Starting The Ups; Starting The Ups On Battery Power - Lenovo 5594-6KX Installation And User Manual

Chapter 5. Operation

UPS startup and shutdown

Follow these instructions to start and stop the UPS.

Starting the UPS

About this task
Note: Verify that the total equipment ratings do not exceed the UPS capacity to
prevent an overload alarm.
To start the UPS:
Procedure
1. Verify that the internal batteries are connected. See "Connecting the internal
2. If optional EBMs are installed, verify that the EBM are connected to the UPS.
3. Verify that the UPS terminal blocks are connected to the AC source.
4. Set the upstream circuit breaker (not provided) to the "I" (on) position to switch
5. Verify that the UPS status screen shows
6. Press the
7. Check the UPS front panel display for active alarms or notices. Resolve any
8. Verify that the
What to do next
Note: The internal batteries charge to 90% capacity in less than 3 hours. However,
the batteries should charge for 48 hours after installation or long-term storage.

Starting the UPS on battery power

About this task
Note: Before using this feature, the UPS must have been powered by utility power
with output enabled at least once. Battery start can be disabled. See the Cold start
setting in ON/OFF settings.
To start the UPS on battery power:
© Copyright Lenovo 2015
battery pack" on page 19.
See "Connecting the EBM(s)" on page 20.
on the utility power. The UPS front panel display illuminates and shows the
Lenovo logo.
button on the UPS front panel for at least 3 seconds.
The UPS front panel display changes status to "UPS starting...".
active alarms before continuing. See the Troubleshooting section.
If the indicator is on, do not proceed until all alarms are clear. Check the
UPS status from the front panel to view the active alarms. Correct the alarms
and restart if necessary.
indicator illuminates solid, indicating that the UPS is
operating normally and powering the equipment.
, press to restart.
27