Batch Mode Beep; Batch Mode Storage - Honeywell Xenon 1900 User Manual

Persistent Batch Mode is the same as Inventory Batch Mode, except that once the data is transmitted to the base or Access
Point, it is retained in the scanner. If you want to transmit more than once, you can do so using this mode. In order to clear the
scanner's buffer, you must scan
Default = Batch Mode Off.
* Batch Mode Off
Inventory Batch Mode

Batch Mode Beep

When scanning in Inventory Batch Mode
Granit scanner, it also vibrates. When Batch Mode Beep is On, you will also hear a click when each bar code is sent to the
host. If you do not want to hear these clicks, scan Batch Mode Beep Off. Default = Batch Mode Beep On.
Batch Mode Beep Off

Batch Mode Storage

When a scanner is storing data during a Batch Mode process, you can select whether the data is stored in Flash memory
or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to powering down. The data will still be
there when the scanner powers back up. However, the scanner will power down, even with untransmitted data, if it reaches
a power down timeout or if the battery power is very low.
3 - 14
Clear All Codes (see page
(page 3-14), the scanner beeps every time a bar code is scanned. If using a
3-17).
Automatic Batch Mode
Persistent Batch Mode
* Batch Mode Beep On