Base Alarm Volume
High
Scanner Alarm Volume
High
Out-of-Range Delay
When using the Out-of-Range Alarm settings, the length of the delay for the alarm is set with an Out-of-Range Delay.
When the scanner is out of range of the base or Access Point, the alarm will delay for a set length of time before going off.
Set the length (in seconds) for a timeout by scanning the following bar code, then setting the timeout (from 0-3,000 sec-
onds) by scanning digits from the
Programming Chart
inside the back cover of this manual, then scanning Save. Default =
No Delay.
Out-of-Range Delay
5 - 6