Chapter 5 - Healthcare Settings; Quiet Operations - Combination Codes; Silent Mode With Flashing Led; Silent Mode With Long Led - Honeywell Xenon 1900 User Manual

5
Healthcare Settings
The following settings have been developed to enhance scanning in a healthcare environment. These settings are only sup-
ported by the Xenon 1902HC scanner and base. They allow you to set quickly configure streaming presentation, and to set the
scanner and base to quiet modes for scanning that does not disturb resting patients.

Quiet Operations - Combination Codes

The following combination codes program your Xenon HC scanner and base for silent or quiet settings using a single program-
ming code. If you wish to program some of these quiet settings individually, refer to
Settings, beginning on page 5-3.

Silent Mode with Flashing LED

Scan the following bar code to completely silence the base and scanner. The scanner beep, base beep, base and scanner
power up beep, and scanner linking sounds are all silenced. When a bar code is scanned, the LED and aimer flash 5
times. Green indicates a good scan, red indicates a bad scan.

Silent Mode with Long LED

Scan the following bar code to completely silence the base and scanner. The scanner beep, base beep, base and scanner
power up beep, and scanner linking sounds are all silenced. When a bar code is scanned, the LED and aimer remain sol-
idly lit for 1 second. Green indicates a good scan, red indicates a bad scan.

Very Low Beeper (Nighttime Mode)

The following bar code silences the base, and sets the scanner for a very low beep when reading bar codes. After scan-
ning this code, the base beep, base and scanner power up beep, and scanner linking sounds are all silenced. When a bar
code is scanned, the scanner emits a very soft beep.
Silent Mode with Flashing LED
Silent Mode with Long LED
Nighttime Mode
Quiet Operations - LED and Volume
5 - 1