Mitsubishi S3L Service Manual page 34

ELECTRICAL SYSTEM
t
Battery
(12 volts)
Connector disconnected
Figure 9 Connections for testing pull-in coil
t
Connector disconnected
Battery
(12 volts)
Figure 10 Connections for testing hold-in coil
34 / 195 34 / 195
Item
Model
Nominal output, V – kW
Terminal voltage, V
Current draw, A
Speed, rpm
3. Magnetic switch
1) Disconnect the connector from the M terminal
of the magnetic switch.
2) Connect the magnetic switch to a 12 volt
battery with a switch as shown in the
illustration to test the pull-in coil. Close the
switch to see if the pinion shifts. If the piston
fails to shift, the magnetic switch is faulty.
CAUTION
Due to the amount of current being passed through
the solenoid series winding, this test must be made
within 10 seconds.
3) Connect the magnetic switch to a 12 volt
battery with a switch as shown in the
illustration to test the pull-in coil. Close the
switch to see if the pinion shifts. If the piston
fails to shift, the magnetic switch is faulty.
CAUTION
Due to the amount of current being passed through
the solenoid series winding, this test must be made
within 10 seconds.
ENGLISH Service Manual Mitsubishi SL-Series diesel engines
DISASSEMBLY
Standard
M8T70471 M1T68281
12 – 2.0 12 – 1.7
11 11.5
130 100
maximum maximum
3 850 3 000
minimum minimum
Version 08/2004