Installing The Interface Cable - Motorola 6840420Z01-AD Start Here Manual

User Interface Module
The User Interface Module (UIM) cable can be mounted in
several ways to provide a safe and comfortable
environment for use.
Audio Connections
You can install the system's audio components in one of
2 ways:
External Speaker
If you are installing the system with the external speaker,
you MUST leave the audio output (+/-) lines disconnected.
(See "Power Connections" on page 49.) The external
speaker should be connected to the interface cable.
Vehicle Radio
If you intend to connect the system to the vehicle radio to
control audio level and the radio supports it, you must
connect the audio output (+/-) lines to your vehicle's
entertainment system.
Note: The system's handsfree audio has been optimized
for the external speaker. Routing the audio output through
the vehicle's entertainment system may alter the
handsfree audio performance.
Installing the Electronic Module
The best location for the electronic module is under the
vehicle's dash. The box must be protected from dirt and
moisture and have adequate space for cooling and to allow
for cable connection.
For optimal Bluetooth
module in a central location within the vehicle. Do not
place it behind or within large areas of metal.
The location of the electronic module MUST NOT interfere
with deployment of the vehicles air bags. Do NOT locate
the electronic module in the vehicle's trunk (boot).

Installing the Interface Cable

Caution: Failure to follow the steps below may cause the
accessory not to work properly and may cause damage to
the car kit.
The interface cable has integral fuses on the power lines
(VBatt and Ign).
Note: When installing the system into vehicles without an
available adapter harness, remove the white 8-pin
connector.
11 12
®
performance, mount the electronic