Connect The Iso Cable - Motorola TK30 User Manual

connect the ISO cable

Use the ISO cable to connect the car kit to your vehicle's
wiring. It connects the vehicle's power, ignition, and
entertainment system to the car kit.
1 Disconnect battery from vehicle.
Caution: Removing battery power may set trouble
codes that can only be reset by a factory diagnostic
tool on some vehicles. Please check with your vehicle
manufacturer if you are unsure how your vehicle may
react.
2 Disconnect appropriate connections on the vehicle
audio system to allow installation of the ISO cable (and
adapters, if needed).
3 Connect cable connectors H and I to the vehicle
entertainment system.
4 Connect cable connector G to the vehicle wiring
harness ISO connectors.
5 Connect cable connector F to vehicle integration kit
connector A (shown on page 4).
Note: Make sure cable connector is plugged all the
way into the vehicle integration kit.
should be no gap
between connector
and housing
6 Reconnect battery to vehicle.
Failure to follow these steps may cause the harness not to
work properly and could damage the harness.
install the harness 5