Brake Fluid Level Inspection /Refilling; Rubber Cover Inspection For Wire And Cable - KYMCO PEOPLE 125 User Manual

(9) BRAKE FLUID LEVEL INSPECTION
/REFILLING
Remove the 2 screws from the brake fluid tank
and take off the cover.
Add recommended brake fluid DOT-3 into the
tank until the fluid level reaches the upper limit
and then put on the cover and tighten the screws.
Recommended Brake Fluid: DOT-3
CAUTION:
Do not mix brake fluid of different brands. It may
cause brake failure and is very dangerous. When
refilling brake fluid, use towels to cover and
protect the painted and coated surfaces. (Replace
at 10000km or every year.)
(10) RUBBER COVER INSPECTION FOR
WIRE AND CABLE
The cable cores are protected by the rubber cover
outside the connector. Check the rubber cover
frequently for proper installation.
When washing the motorcycle, do not flush the
rubber cover directly or brush it. Use a wet rag to
wipe off dirt and dust.
Rubber Cover
Check Points
- 35 -