Fujitsu Siemens Computers LifeBook S6010 User Manual page 98

4 Connect the AC adapter to the computer and turn the power on.
5 Click the Start button and select Control Panel.
6 Click Performance and Maintenance, then Power Option.
7 Click of "System standby" on the Power Schemes tab, and select "Never."
8 Click of "System suspended" and select "Never."
9 Click OK.
10 Make all necessary network settings.
IMPORTANT
• When you are connecting to a local area network (or the Internet) using the LAN function,
you should not put your computer into Standby or Hibernation mode. Doing so could
cause your computer to break connection with the network or the Internet, depending
on the environment in which your computer is being used.
Turn off your computer if you are not using the computer for the connection.
• Your computer is configured by default so that the LAN device will not operate if you turn
on the computer before connecting a LAN cable to it when the computer is powered by
the internal battery.
Critical Points
When disconnecting the LAN cable from the LAN port, pull it while pushing in the tab to
avoid damage to the plug.
When using the LAN device, you should preferably power your computer from the AC adapter
since the LAN device consumes a large amount of electrical power.
The built-in LAN device in your computer cannot be used along with any LAN card.
If the LAN device does not operate normally, make all necessary settings.
To avoid damage to the LAN device, do not connect a LAN cable to a modular jack.
85