Troubleshooting - Vello FreeWave Fusion Basic User Manual

TROUBLESHOOTING

Problems with the FreeWave Fusion Basic
can usually be traced to the following causes:
• Check the contact between the flash's
hot-shoe foot and the Receiver's hot shoe
to be certain that the flash is properly
seated. Make sure the light's locking
switch is set to the lock position when
mounted in the Receiver's hot shoe.
• Make sure that the Receiver is powered
on and at the correct setting.
• Check that the shutter release cable and/
28
or studio light cable are in good condition
and properly connected.
• If you encounter any interference on
the initial setting, remove the batteries
from the Transmitter and Receiver, and
change the channel by rearranging the
channel selector switches to a different
combination. Take care to ensure that
both the Transmitter and Receiver are
set identically. Then replace the batteries
and proceed.
• When using the FreeWave Fusion Basic
as a shutter release, your camera may not
be able to release the shutter if the lens
is set to Auto Focus and focus cannot be
achieved on a subject. Switch your camera
to manual focus and focus the camera to
ensure proper shutter release.