WIRELESSLY TRIGGER A STUDIO FLASH
Using the FreeWave Fusion Basic helps you
to eliminate cord clutter when setting up
studio lights. You can also trigger multiple
lights by using additional FreeWave Fusion
Basic Receivers (available separately).
To use the FreeWave Fusion Basic
to wirelessly trigger a studio flash,
follow these instructions:
1. Check to be sure that both the
Transmitter and Receiver are set to the
same channel.
2. Turn your camera and Receiver Off.
3. Use the included studio light (2.5 mm
to 3.5 mm) sync cable to connect to a
studio flash.
4. Plug the 2.5 mm side of the cable into the
Receiver's flash sync [
] port.
19