Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vello Freewave micro
Summary of Contents for Vello Freewave micro
- Page 1 FREEWAVE MICRO WIRELESS REMOTE SHUTTER RELEASE...
- Page 2 Nikon. This compact set includes the same area. a small transmitter and a low- The FreeWave Micro also allows profile receiver that sits directly you to take photographs without The FreeWave Micro transmitter touching your camera—a great on the 10-pin remote terminal—...
-
Page 3: Key Features
2.4 GHz Radio Frequency: reduced interference and improved wireless signal quality. Bulb Mode Release: when the camera is in Bulb mode, the FreeWave Micro remote control Extended Range: operates at up to 328′ (100 m), depending on conditions. can open the shutter at the beginning of the... - Page 4 • Do not handle with wet hands or immerse in or equipment—doing so will void the warranty, and expose to water or rain. Failure to observe this Vello will not be responsible for any damage. precaution can result in fire or electric shock. • Handle the unit with care.
-
Page 5: Features Diagram
FEATURES DIAGRAM Antenna Lanyard hook 16-channel switch Receiver Transmitter Power LED Focus LED Shutter LED Power switch Locking wheel 10 pin connection to the camera. Channel selection pin Protective sliding cover Shutter release button LED Indicator Focus—vivid blue / Shutter—dim blue / Shooting alarm—red Battery compartment door Lanyard... - Page 6 INSTRUCTIONS To get the most from your FreeWave Micro Wireless Remote Control, please read this manual. Setting Up the Receiver 2. Turn the receiver slightly until you feel that it’s seated The camera must have a 10-pin properly in the terminal.
- Page 7 4. Turn the receiver on by 7. To turn the receiver off, press pressing the power button. the power switch and hold it for approximately one second. 5. The red Power LED on the The red Power LED will turn receiver will blink on and off off.
- Page 8 Setting Up the Transmitter 4. Slide the battery chamber cover closed. Please follow these directions to set up the transmitter. 5. To activate autofocus, press the shutter button on the 1. Press down on the knurled transmitter halfway down. area on the back of the When autofocus is engaged, transmitter and slide open the the indicator LED will become...
-
Page 9: Setting The Channel
Be sure to set the same channel on the transmitter and the receiver. This allows you to use the Freewave Micro Wireless Remote Control without interference from other devices using radio frequencies in the same area. The channel selection pin attached to the included lanyard helps you to adjust the channels. - Page 10 USING THE FREEWAVE MICRO WIRELESS REMOTE SHUTTER RELEASE FOR NIKON After you attach the receiver to alarm LED on the transmitter of the camera is open. When your camera, you can use the will light up to confirm that the...
-
Page 11: Troubleshooting
TROUBLESHOOTING Transmitter Receiver Transmitter light does not blink Insert a fresh battery into the battery chamber, ensuring that the polarity is correct. Transmitter light blinks, but receiver light does Check to be sure that the power switch for the receiver is in the not blink On position. -
Page 12: Compatible Cameras
COMPATIBLE CAMERAS Nikon D800 / D700 / D300 / D300s / D200 / D100 ® (battery grip required) / D3 / D3s / D3x / D2 D2x / D2Hs / D2H / D1H / D1... -
Page 13: Specifications
SPECIFICATIONS Transmitter Receiver Frequency 2.427 GHz to 2.457 GHz Channels Maximum Range 328′ (100 m) Battery 1x AAA Powered by camera Operating Temperature Range -4 to 122°F (-20 to 50°C) Dimensions 2.83 × 0.86 × 0.90″ 2.75 × 1.33 × 0.67″ (82 ×... -
Page 14: Fcc Compliance
FCC COMPLIANCE This equipment generates, uses, and can radiate 1. Reorient or relocate the receiving antenna; radio frequency energy, and, if not installed and 2. Increase the distance between the equipment and used in accordance with the instructions, may cause the receiver. -
Page 15: Warranty
WARRANTY Vello provides a limited warranty that this product is free from defects in materials and workmanship to the original purchaser under normal use for a period of one (1) year from the original purchase date, or thirty (30) days after replacement whichever occurs later. Vello’s responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at its option, of any product which fails during normal consumer use. - Page 16 © Copyright 2013 Gradus Group. www.vellogear.com All other trademarks are the property of their respective owners...