Electric Motor Installation - Hangar 9 frenzy 100 Assembly Manual

Electric Motor Installation

Required Parts
• Fuselage
• #4 washer (2)
• 8-32 blind nut (2)
• Plywood ESC mount
• Hook and loop strap (2)
• 8-32 blind nut (trimmed)
• 8-32 x 3-inch machine screw (3)
7
• 7
/ -inch 65mm standoff (3)
8
• #4 x 3/8-inch sheet metal screw (5)
• 4-40 x 1/2-inch socket head screw (2)
Required Tools and Adhesives
• Hex wrench: 3/32-inch
• Phillips screwdriver

Step 1
Look at the 3-point mount to determine which of the
mounting tabs is the longer of the three. This will face
down and to the right of the fuselage when installed.
• 3-point motor mount
• 4-40 blind nut (2)
• Battery tray
• 30-minute epoxy

Step 2
Attach the 3-point mount to the motor. Make note of the
position of the long tab of the mount in relationship to the
motor wires. Attach any adapters to the motor following
the instructions provided with the motor.

Step 3
Attach the motor and 3-point mount to the firewall using
the three 8-32 x 3-inch machine screws. A special 8-32
blind nut has been provided that has been trimmed to
fit against the inside of the fuselage in the upper right
location behind the firewall.
23