Hangar 9 frenzy 100 Assembly Manual page 22

Glow Engine Installation

Step 13
Attach the fuel line to the carburetor. We used a fuel dot to
allow fueling of the tank from outside the cowling.

Step 14
Slide the cowling onto the fuselage. Allow the drive
washer to extend roughly 1/8-inch (3mm) forward of
the cowling. Use a 1/16-inch (1.5mm) drill to drill two
locations on each side of the cowl and one on the top
for the cowl screws.
22

Step 15
Make any necessary holes in the cowling to clear
the muffler, needle valve and to install the fuel dot.
Attach the cowl to the fuselage using five #4 x 3/8-inch
sheet metal screws.

Step 16
Attach the propeller and spinner to complete the
engine installation.