Hangar 9 frenzy 100 Assembly Manual page 24

Electric Motor Installation

Step 4
Assemble and install the plywood ESC mount to the
firewall using two 4-40 x 1/2-inch socket head screws,
two #4 washers and two 4-40 blind nuts. Plug the motor
into the ESC and secure the ESC to the mount.

Step 5
Pass the hook and loop straps through the battery tray
as shown. Installing them now will be much easier,
rather than after the tray has been installed. Note that the
tray has an angle on the front which matches the angle
of the firewall.
24

Step 6
Test fit the battery tray into the fuselage. Use 30-minute
epoxy to glue the battery tray in the fuselage.

Step 7
Secure the battery inside the fuselage using the straps.
It is suggested to place hook and loop between the tray
and battery to prevent the battery from sliding forward or
rearward in flight.