Aaeon SBC-670S Manual page 67

8. If the following message appears, click New to replace the
existing driver and skip to Step 10.
The driver(s) for this SCSI Adapter are aready on the system.
Do you want to use the currently installed driver(s) or install
new one(s).
If the following message appears, continue with Step 9:
Please enter the full path to the Windows NT SCSI Adapter
files.
9. Change the path to the directory (i.e., a:\winnt\3_5) with the
desired device driver, then click Continue.
The device driver is copied to your system disk and the
Windows NT configuration is updated so that the new device
driver loads when Windows NT reboots.
10.When the installtion is complete, Windows NT Setup again
displays a list of currently installed host adapter types. Verify
that the new host adapter appears on the list; the string should
look similar to "Adaptec AHA-294x/AHA-394x/AHA-4944 or
AIC-78xx PCI SCSI Controller (NT 3.5x)".
11. Add other types of host adapters if necessary (see Step 4
above), or click close to exit the SCSI adapters portion of
Windows NT Setup, and then close the program.
12.When you see this message, click OK to exit:
The changes you have made will not take effect until the
computer is restarted.
If this message does not appear, no changes have been made to
the Windows NT system configuration.
13.Restart your computer andWindows NT. It is possible that
some drive letter assignments may change from the previous
configuration.