Table of Contents
Advertisement
The Ultra-Wide SCSI Connector is a 68-pin, 16-bit SCSI Connector.
If you are connecting internal SCSI devices, make sure you have an
internal SCSI cable with enough connectors to accommodate all of
your devices.
1. Prepare each SCSI device for installation. Be sure to configure
the devices SCSI ID and terminators (see the device's documen-
tation).
2. Install the SCSI device in your system
3. Plug one end of the internal SCSI cable into the host adapter's
internal SCSI Connector.
4. Plug the remaining SCSI cable connectors into the correspond-
ing connectors on the back of each individual device.
5. Connect the DC power cable into the SCSI's power connector.
The pin assignments are shown on the opposite page:
Advertisement
Table of Contents
