Instructions For Use - Televes T.0X 565301 User Manual

8. Instructions for use

The first item displayed after
connecting the Programming Unit
PCT UNIVERSAL
to the front of the transmodulator
is the Programming Unit's firmware
version:
A B C
PCT firmware
version
------------
V:5.03.00001
Sub-menu 1 Sub-menu 1
Sub-menu 2 Sub-menu 2
▲ ▲
▼ ▼
Sub-menu N Sub-menu N
The configuration screens are organized in three
main sections as shown in the figure (refer to
Appendix 4 for a detailed diagram):
• Section A: MAIN (TRANSCODER) MENUS
• Section B: CONFIGURATION (COMMON) MENUS
• Section C: MONITORING MENUS
LEDs A, B and C will light up indicating the currently
selected section.
The ■ button toggles between sections.
To move up and down a section press the ▲ and
▼ buttons .
To save data, press and hold the ■ button.
In each individual screen, pressing the
enables the "Edit mode" and the selected
parameter can then be modified by using the ▲ or
▼ buttons.
In those cases where the cursor may be placed
in more than one position (for example an input
Sub-menu 1
frequency with several digits) press the
many times as needed to position the cursor over
the desired field.
Sub-menu 2
To move to a different screen, press the
until the cursor stops blinking (cursor is OFF,
leaving "Edit mode").
▲
▼
Sub-menu N
8.1 - MAIN menu (LED A is ON)
Transcoder selection
The first menu allows the selection of one of the
unit's tuners, A or B. Once selected, the remaining
submenus in this section will refer to the
parameters of the selected tuner.
SELECT
TRANSCODER
TUNER A
●
Press the button to enter "Edit mode" so the last
line of the display starts to blink (cursor ON). You
can now select one of the tuners (A or B) using the
●
button
▲ and ▼ buttons. To exit "Edit Mode" press the
button until the cursor stops blinking (cursor OFF)
An indication of the input and output status is
provided in each sub-menu of section A (main
●
button as menus). The top leftmost character will be "•" if the
input is locked and "-" otherwise. Similarly, the top
rightmost character will be "•" when the output is
locked and "-" otherwise.
●
button
Input frequency/channel selection
Use this menu to select the input frequency/
channel according to the mode selected in the
corresponding CONFIGURATION menu.
The display will show the following information in
each case:
17
EN
SELECT
TRANSCODER
TUNER A
●