Televes T.0X 565301 User Manual page 19

Aftern entering "edit mode" with the
user can move through the list with the help of the
and keys.
The service selected in this menu can the be edited
in the following menus if the unit is working in
PROCESSING or MULTIPLEXING mode.
This menu will not be displayed if the input is
DISABLED.
Service name edition
This menu is available in PROCESSING and
MULTIPLEXING modes. The user can edit the output
service name (the 7 character short_name field in
the output VCT table, in case of annex B output, or
the service_name field in the output SDT table in
case of annex A output). The edited service must
be selected in the previous menu.
• TUNER B •
Serv. name
IN: WMAR HD
OUT: SERVHD
The input service name is provided as a reference.
After the scan of a new input transponder, the
output names are set to be the same as the input
names.
This menu will not be displayed if the input is
DISABLED.
Service virtual channel number edition
key, the
This menu is available when the QAM output
mode is annex B and the unit is in PROCESSING or
MULTIPLEXING mode. The user can edit the output
service´s virtual channel number and format.
The edited service must be selected in the service
list menu.
• TUNER
WMAR HD VCT2
IN:
OUT: 002-001
The input service name and VCN are provided as
a reference.
The possible options for the format of the VCN are :
- VCT1: one-part channel number. This option is
only possible when the type of VCT output table
is CVCT (cable).
- VCT2: major-minor. This option is possible for
both TVCT and CVCT output tables.
Valid ranges for VCNs are :
- 999-999 for major-minor format (VCT2)
- 0-16383 for one-part formatr (VCT1)
After the scan of a new input signal, the output
VCNs are set tu the input values.
This menu will not be displayed if the input is
DISABLED.
Output frequency/ channel selection
This menu allows the user to select the output
frequency/channel according to the mode selected
in the corresponding CONFIGURATION menu.
• TUNER
A •
2-1
In channel mode, the output QAM channel is
selected (see Appendix 1). The last line of the
display will show both the output channel number
and its center frequency (Channel # = center
frequency).
In frequency mode, the user can select any
frequency value between 12 and 1002 MHz.
The two outputs in an HDTV TRANSMODULATOR
- Dual ATSC/QAM to QAM are completely agile,
so the two QAM channels can be positioned
anywhere in the spectrum allowing for maximum
flexibility.
Output modulation selection
Using this menu, the user selects the desired
constellation of the output QAM modulation. The
possible options available depend on the QAM
output mode selected in the CONFIGURATION
menu:
- 16, 32, 64, 128, 256, 512 and1024 QAM for annex A
- 64 and 256 QAM for annex B
- TUNER
A •
SELECT OUT
SELECT OUT
FREQUENCY
CHANNEL
245MHz
2 = 57MHz
19
A -
EN