Dalsa Pantera TF 11M4 User Manual page 54

54
Command
Parameters:
i = integer
f = float
strobe control
t = tap
pulse
shutter control
timing
set exposure
time
set exposure
mode
set output
mode
set pretrigger
set system gain
DALSA
Syntax Parameters
scp f f
sct f f
set f
sem i
sos i
sp i
ssg t i
Pantera TF 11M and 6M User's Manual
Description
Sets the strobe pulse timing. The first value is
the time the keep the signal high (or on) in a
range from 0-65 in .001 millisecond steps. The
second value is the time in milliseconds to
keep the value low (or off).
Controls the shutter signal's opening and
closing times. The first value is the time to
keep the shutter open in a range from 0 to 65
in .001 millisecond steps. The second value is
the shutter's closing time in milliseconds.
Set the exposure time in exposure mode 8 or
6. Value is a floating-point number in
milliseconds in a range from .001 to
16000.000.
Set the exposure mode. Available values are:
4: Smart EXSYNC
6: External SYNC, programmable exposure
time
8: (Factory Setting) Internal sync,
programmable exposure time
Sets whether to read out data using one or
two taps. Use 1 for one tap or 2 for two taps.
Set the pretrigger to a value from 0 or 15
The first value is the tap value. Either 1 for
the left tap or 2 for the right tap. The second
value is the analog gain with an available
range from 0-4095.
03-032-10096-05