Junction Box Installation - Heat & Glo Cosmo-SXT-IPI Owner's Manual

Note: Appliance will not operate
unless properly grounded.
Figure 9.1 Intellifi re Pilot Ignition (IPI) Wiring Diagram
D. Junction Box Installation
JUNCTION
BOX
SCREW
PROVIDED
Figure 9.2 Junction box installation
IGNITION MODULE 3 VAC
TRANSFORMER
3 VAC
PLUG-IN
JUNCTION BOX ACCESS
SIDEWALL
Heat & Glo • Cosmo-SXT-IPI, Cosmo-GXT-IPI • 2203-900 Rev. E • 1/10
INTERMITTENT
PILOT IGNITOR
ORG
WHT
GROUND TO
FIREPLACE
CHASSIS*
ORG
BLK
RED
VALVE
REMOTE
JUMPER WIRE
ON
OFF
ON/OFF
SWITCH
Optional Accessories
Wiring for optional accessories should be done now to
avoid reconstruction.
Connecting the electrical junction box is required if using
a blower or remote.
• Plug the cord into a convenient outlet.
• An electrician may install an outlet box inside the
fi replace. Place the outlet in the lower, back corner of
the fi replace.
• Must use cord supplied.
• Avoid sharp corners.
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
CAUTION
WARNING
Shock hazard.
• Replace damaged wire with type 105º C rated
wire.
• Wire must have high temperature insulation.
17