Malfunctions; Technical Data - Taski ergodisc 1200 Instructions Of Use

Malfunctions

Malfunction
Machine does not run
machine is inoperable,
the control light is on
Pad does not rotate
Machine does not reach
rated speed, over-
current activates
Machine is running
uneasy
House installation
safety fuse is activates
Spray pump is working,
cleaning solution is not
coming out

Technical data

Machine
type
Working width
Dimensions (L x W x H)
machine weight
Rated voltage
Possible causes
No power supply
Guide rod in upright
position
safety switch defect
Machine was
overloaded, over-
current trigger was
activated
Motor runs but not tool
Machine overloaded
Undervoltage: Power
cord is too long
Pad is deformed or
damaged
Mains overload
Cleaning solution has
dried up in spray unit or
tube is blocked up
Troubleshooting
t
Connect the power plug into the wall
socket.
t
Place machine in working position
t
Call for technical service
On the last page of these instructions of
use
t
Wait a while, try again (over-current
trigger will reset itself automatically)
t
drive belt is torn or loose
t
Call for technical service
On the last page of these instructions of
use
t
Check working technique
t
Remove extension
t
Check power supply voltage
t
Replace
t
Electric circuit discharged or choose
another circuit (socket)
t
Clean the spray unit
t
Replace
page
7
5
1200
50SHS/
50SHSL
50 cm
95x52x118 cm
42 kg
230-240V dc
14