Samsung SHR-2080 User Manual page 33

SHR-2160/2162/2080/2082 USER'S MANUAL
HDD Mode Setup
HDD End Mode
Stop : Stops recording when HDD is full during the recording.
Overwrite : Deletes the original data and save a new data when HDD is full during the
recording.
HDD End Beep
On : Beeps when the HDD is full in the recording mode.
Off : Although the HDD is full in the recording mode, the beep sound is not heard.
Note Note
If the HDD is full, the Disk Full Icon(
Caution
Caution
When you want to overwrite the data you want to backup and HDD repeat recording is set to
overwrite, backup starts.
You can change the time or cancel backup.
[Disk Overwrite]
In the overwrite Mode, the previous Event data is deleted and the mode is changed.
5-9
English
) is appeared.
Remote control Device
MENU for the use of Samsung system keyboard
Device
A Remote Control Device, being connected to the RS485 port.
ID
This is a private ID of SHR-2160/2162/2080/2082.
This private ID is essential for SSC-2000 because SSC-2000 can control many
SHR-2160/2162/2080/2082 DVRs.
Baudrate
Baudrate to communicate with SSC-2000
It should be same to SSC-2000 Baudrate for communication.
Parity
Sets up one of None / Even / Odd.
Data
Sets up either 7 or 8.
Stop
Sets up either 1 or 2.
Duplex
Sets up either Half Duplex or Full Duplex.
Remocon
Sets the remote control to on/off.
You can set the remote control's ID to 0-99.
Note
Note
You cannot use the PTZ device and remote control device at the same time, because of
communication problems
In PTZ control mode, DVR's PTZ mode is canceled when remote control mode is connected,
and the remote control device is disconnected when the DVR changes to PTZ mode while
controlling the DVR with a remote control device.
Refer to the remote control device manual on how to control the DVR's PTZ device in the
remote control device.
5-10
English