Installation Requirements; Tools And Parts; Location Requirements; Product Dimensions - KitchenAid KXW9748YSS Installation Instructions And Use & Care Manual

Tools and Parts

Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
Tools needed:
Level
■
Drill
■
Drill 1 / " (3 cm) drill bit
1
■
4
/ " (2.4 mm) drill bit if installing into wood
3
■
32
Pencil
■
Wire stripper or utility knife
■
Tape measure or ruler
■
Pliers
■
Caulking gun and weatherproof caulking compound
■
Vent clamps
■
Jigsaw or keyhole saw
■
Flat-blade screwdriver
■
Metal snips
■
Phillips screwdriver
■
Scissors
■
Parts needed:
Home power supply cable
■
1 - / " (12.7 mm) UL listed or CSA approved strain relief
1
■
2
3 UL listed wire connectors
■
1 wall or roof cap
■
Metal vent system
■
2 - 175-watt max heat lamp bulbs
■
Blower motor system - internal or external (see "Blower
■
Motor System" in the "Accessories" section).

Parts supplied:

Remove parts from packages. Check that all parts are included.
2 metal grease filters for 36" (91.4 cm) models
■
3 metal grease filters for 48" (121.9 cm) models
Damper
■
2 - Vent cover support brackets
■
2 - 10 x 50 mm wall anchor
■
2 - 8 x 40 mm wall anchor
■
2 - D5.3 x 20 mm washers
■
4 - 5 x 45 mm screws
■
9 - 4.2 x 8 mm screws
■
T20 TORX adapter
® ®†
■
† TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
4

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial/rating plate. The model/serial/
rating plate is located inside the range hood on the rear wall
of the range hood.
This range hood is recommended for use with cooktops
with a maximum total rating of 105,000 BTUs or less.
Canopy range hood location should be away from strong draft
areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance.
The canopy range hood is factory set for venting through
the roof or through the wall.
All openings in ceiling and wall where canopy range hood
will be installed must be sealed.
For Mobile Home Installations:
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or when
such standard is not applicable, the standard for Manufactured
Home Installation 1982 (Manufactured Home Sites, Communities
and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with
local codes.

Product Dimensions

Vented Installations:
11⁵⁄₁₆" (28.7 cm)
22³⁄₄" (57.8 cm)
36" (91.4 cm)
or 48" (121.9 cm)
32³⁄₈" (82.2 cm) min.
50¹¹⁄₁₆" (128.7 cm) max.
7⁷⁄₈" (20.0 cm)
25" (63.5 cm)