Table of Contents
Advertisement
Available languages
Available languages
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Level
Drill
¹⁄₈" (3 mm) drill bit
³⁄₄" (19 mm) drill bit
Pencil
Pliers
Wire stripper or utility knife
Tape measure or ruler
Caulking gun and weatherproof caulking compound
Phillips screwdriver
Flat-blade screwdriver
T-10 TORX
®†
driver
Saber or keyhole saw
Vent clamps
Metal snips
Parts needed
Home power supply cable
Two ¹⁄₂" (1.3 cm) UL listed or CSA approved strain reliefs
3 UL listed wire connectors
For vented installations, you will also needed:
1 wall or roof cap
Metal vent system
For non-vented (recirculating) installations, you will also
need:
Recirculation Kit Part Number W10356918. See the
"Assistance or Service" section to order.
Optional parts needed:
Wood filler strips for cabinets with recessed bottoms. Length
and thickness determined by recess dimensions. See the
"Prepare Location" section.
Two, 1" x 1" x 5" (25 x 25 x 12.7 cm) wood pieces for cabinet
floor. See the "Prepare Location" section.
Four, 1¹⁄₄" (3.2 cm) wood screws
Parts supplied
Remove parts from packages. Check that all parts are included.
Damper: Part Number W10369162
Hardware package: Part Number W10369160. Includes:
Installation Instructions and Use and Care Guide
2 lower leveling brackets
2 upper leveling brackets
2 - 2.5 x 9.5 mm metal screws
4 - 4.5 x 16 mm wood screws
4 - 5 x 18 mm machine screws
4 - 3.5 x 9.5 mm metal screws
†®TORX is a registered trademark of Saturn Fasteners, Inc.
4
INSTALLATION REQUIREMENTS
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate. The model/serial rating
plate is located behind the filter on the left rear wall of the range
hood.
Range hood location should be away from strong draft areas,
such as windows, doors, and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance. Consult your cooktop/
range manufacturer installation instructions before making any
cutouts.
Grounded electrical outlet is required. See "Electrical
Requirements" section.
The range hood is factory set for vented installations through the
roof or wall. For non-vented (recirculating) installations see "Non-
Vented (recirculating) Installation Through the Soffit/Cabinet" in
the "Prepare Location" section. Recirculation Kit Part Number
W10356918 is available from your dealer or an authorized parts
distributor.
All openings in ceiling and wall where range hood will be installed
must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Advertisement
Table of Contents
