Table of Contents
Advertisement
Power connector
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the system board (see
To remove the power connector cable:
1.
Pull the tab away from the connector (1).
2.
Remove the cable (2) from the left hinge that sits above the power connector.
3.
Remove the power connector (3) from the computer.
Reverse this procedure to install the power connector cable.
54
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
27).
Optical drive on page
Bottom cover on page
System board on page
28).
32).
48).
Spare part number
809295-001
Advertisement
Table of Contents
