Table of Contents
Advertisement
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the fan (see
To remove the heat sink assembly:
1.
Position the computer upright and open it..
2.
If you have a model with discrete graphics, In the order indicated, remove the six Phillips PM2.0×3.0
screws (1) that secure the heat sink to the system board.
3.
Remove the heat sink (2) from the system board.
4.
If you have a model with UMA graphics, In the order indicated, remove the six Phillips PM2.0×3.0 screws
(1) that secure the heat sink to the system board.
44
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
27).
Optical drive on page
Bottom cover on page
Fan on page
42).
28).
32).
Advertisement
Table of Contents
