Checking The Relays - Yamaha YZF-R6(V) 2006 Service Manual

Hide thumbs Also See for YZF-R6(V) 2006:
Table of Contents

Advertisement

Recommended lubricant
Dielectric grease
10.Install:
• Fuel tank bracket
• Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS28040

CHECKING THE RELAYS

Check each switch for continuity with the pocket
tester. If the continuity reading is incorrect, re-
place the relay.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
1. Disconnect the relay from the wire harness.
2. Connect the pocket tester (Ω × 1) and battery
(12 V) to the relay terminal as shown.
Check the relay operation.
Out of specification → Replace.
Starter relay
1.
3
R
B
4
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
R
R
R/
R/W
L /
W
2
1
ELECTRICAL COMPONENTS
Relay unit (starting circuit cut-off relay)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
Relay unit (fuel pump relay)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")
Headlight relay (on/off)
1. Positive battery terminal
2. Negative battery terminal
8-99

Advertisement

Table of Contents
loading

Table of Contents