Yamaha YZF-R6(V) 2006 Service Manual page 377

Hide thumbs Also See for YZF-R6(V) 2006:
Table of Contents

Advertisement

Fault code No.
19
Diagnostic code No.
Order Item/components and probable
cause
1
Connections
• Main wire harness ECU coupler
2
Open or short circuit in wire harness.
3
Defective sidestand switch.
Fault code No.
20
Diagnostic code No.
Order Item/components and probable
cause
1
Defective intake air pressure sensor
or atmospheric pressure sensor.
Symptom Open circuit is detected in the input lead from the side-
stand switch to the ECU.
20
Sidestand switch
Symptom When the main switch is turned to "ON", the atmospheric
pressure sensor voltage and intake air pressure sensor
voltage differ greatly.
03
Intake air pressure sensor
02
Atmospheric pressure sensor
FUEL INJECTION SYSTEM
Check or maintenance job
• Execute the diagnostic mode.
(Code No. 20)
• Check the coupler for any pins
that may be pulled out.
• Check the locking condition of
the coupler.
• If there is a malfunction, repair it
and connect the coupler se-
curely.
• Repair or replace if there is an
open or short circuit.
• Between ECU coupler and relay
unit coupler.
(blue/yellow–blue/yellow)
• Between relay unit coupler and
sidestand switch coupler.
(blue/black–blue/black)
• Between sidestand switch cou-
pler and engine ground.
(black–black)
• Replace if defective.
Refer to "CHECKING THE
SWITCHES" on page 8-91.
Check or maintenance job
• Execute the diagnostic mode.
(Code Nos. 03, 02)
• Replace if defective.
Refer to "CHECKING THE IN-
TAKE AIR PRESSURE SEN-
SOR" on page 8-110 or
"CHECKING THE ATMO-
SPHERIC PRESSURE SEN-
SOR" on page 8-109.
8-54
Reinstatement
method
If the transmis-
sion is in gear,
retracting the
sidestand.
If the transmis-
sion is in neu-
tral,
reconnecting
the wiring.
Reinstatement
method
Turning the
main switch to
"ON".

Advertisement

Table of Contents
loading

Table of Contents