Yamaha YZF-R6(V) 2006 Service Manual page 18

EC2C01021
CAUTION:
Do not operate the engine if it is overheated.
Air intake temperature display
1. Air intake temperature display
The air intake temperature display indicates the
temperature of the air drawn into the air filter
case. Push the "RESET" button to switch the
coolant temperature display to the air intake
temperature display.
NOTE:
• Even if the air intake temperature is set to be
displayed, the coolant temperature warning
light comes on when the engine overheats.
• When the key is turned to "ON", the coolant
temperature is automatically displayed, even if
the air intake temperature was displayed prior
to turning the key to "OFF".
• When the air intake temperature display is se-
lected, "A" is displayed before the temperature.
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
odometer/trip meter/fuel reserve trip meter/stop-
watch display will indicate a two-digit error code
(e.g., 11, 12, 13).
If the display indicates an error code, note the
code number, and then check the vehicle. Refer
to "FUEL INJECTION SYSTEM" on page 8-33.
EC2C01022
CAUTION:
If the display indicates an error code, the ve-
hicle should be checked as soon as possible
in order to avoid engine damage.
This model is also equipped with a self-diagno-
sis device for the immobilizer system.
If any of the immobilizer system circuits are de-
fective, the immobilizer system indicator light will
flash, and then the odometer/trip meter/fuel re-
serve trip meter/stopwatch display will indicate a
two-digit error code (e.g., 51, 52, 53).
NOTE:
If the display indicates error code 52, this could
be caused by transponder interference. If this er-
ror code appears, try the following.
1
1. Use the code re-registering key to start the
engine.
NOTE:
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, re-register the standard keys.
If the display indicates an error code, note the
code number, and then check the vehicle. Refer
to "IMMOBILIZER SYSTEM" on page 8-77.
EC2C01022
CAUTION:
If the display indicates an error code, the ve-
hicle should be checked as soon as possible
in order to avoid engine damage.
Display brightness and shift timing indicator
light control mode
1. Display brightness
2. Shift timing indicator light
activation/deactivation
3. Shift timing indicator light
This mode cycles through five control functions,
allowing you to make the following settings in the
order listed below.
1-9
FEATURES
2
3
1
1