Yamaha YZF-R6(V) 2006 Service Manual page 17

To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
Odometer, tripmeter, and stopwatch modes
1. Odometer/tripmeters/fuel reserve
tripmeter/stopwatch
Push the "SELECT" button to switch the display
between the odometer mode "ODO", the tripme-
ter modes "TRIP A" and "TRIP B" and the stop-
watch mode in the following order:
TRIP A → TRIP B → ODO → Stopwatch →
TRIP A
If the fuel level warning light comes on, the
odometer display will automatically change to
the fuel reserve tripmeter mode "F-TRIP" and
start counting the distance traveled from that
point. In that case, push the "SELECT" button to
switch the display between the various tripme-
ter, odometer, and stopwatch modes in the fol-
lowing order:
F-TRIP → Stopwatch → TRIP A → TRIP B →
ODO → F-TRIP
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RESET" but-
ton for at least one second. If you do not reset
the fuel reserve tripmeter manually, it will reset
itself automatically and the display will return to
the prior mode after refueling and traveling 5 km
(3 mi).
Stopwatch mode
To change the display to the stopwatch mode,
select it by pushing the "SELECT" button. (The
stopwatch digits will start flashing.) Release the
"SELECT" button, and then push it again for a
few seconds until the stopwatch digits stop
flashing.
Standard measurement:
1. Push the "RESET" button to start the stop-
watch.
2. Push the "SELECT" button to stop the stop-
watch.
3. Push the "SELECT" button again to reset the
stopwatch.
Split-time measurement:
1. Push the "RESET" button to start the stop-
watch.
2. Push the "RESET" button or start switch " "
1
to measure split-times. (The colon ":" will start
flashing.)
3. Push the "RESET" button or start switch " "
to display the final split-time or push the "SE-
LECT" button to stop the stopwatch and dis-
play total elapsed time.
4. Push the "SELECT" button to reset the stop-
watch.
NOTE:
To change the display back to the prior mode,
push the "SELECT" button for a few seconds.
Coolant temperature display
1. Coolant temperature display
The coolant temperature display indicates the
temperature of the coolant. Push the "RESET"
button to switch the coolant temperature display
to the air intake temperature display.
NOTE:
When the coolant temperature display is select-
ed, "C" is displayed for one second, and then the
coolant temperature is displayed.
1-8
FEATURES
1